Autogenous cutting of pieces takes place on two numerically controlled cutters  with Messer-Griesheims cutting technology.


 way of cutting   material      thickness    tolerance
 autogen  low-alloy steel  8-250 mm  ISO 9013 class B

The possibility of punching through metal is of course subjected to the thickness of individual sheets. With our mechanization the punching through the material up to a thickness of 160 mm is possible, if the ratio of thickness: hole is 1:1 (thickness 40 mm : hole 40 mm), but not less than 30 mm.

  For thickness greater than 161 mm pre-drilling of sheet metal is necessary.


IMG 2664